Introduction
In this section, we will explore specifics about the generation 2 devices. On this page, you will find general information like the GPIO pinout and where to put the jumper if you need it.
#
PinoutThis image is an overview of the GPIO pinout of the 2nd generation AutoPi.
Pins marked with "in use" cannot be used for anything else. This will interrupt the functionality of the AutoPi. This I2C bus is used by the AutoPi, but can be shared with other devices.
All other pins are free and their functionality follows that of the Raspberry Pi.
note
If you'd like to discuss this topic with us or other fellow community members, you can do so on our community page dedicated for this guide: AutoPi GPIO Pinout
#
JumperThis is a picture of the location of the 5V FORCE pins. You can put a jumper on these pins to prevent the AutoPi from going to hibernation. More info here.