Skip to main content

Power

Battery#

NameDescriptionTypeDefaultUnit
READ INTERVALHow often should the battery voltage be read out and checked? Disabled if set to zero.int5s

Critical Level#

NameDescriptionTypeDefaultUnit
VOLTAGESpecifies the voltage threshold where the device should trigger the 'vehicle/battery/critical_level' event and then go into hibernation. To have any effect, this value must be greater than the safety cut-out voltage.float12.3V
DURATIONHow long should the specified voltage remain before triggering the 'vehicle/battery/critical_level' event.int180s

Firmware#

NameDescriptionTypeDefaultUnit
AUTO UPDATEAutomatic update of the firmware on the power management chip?boolTrue-
VERSIONVersion number of the power management firmware.str2.2-

Modem#

NameDescriptionTypeDefaultUnit
POWER SAVEPut modem into lower power mode during sleep? When enabled it is no longer possible to wakup device on SMS.boolTrue-

Safety Cut-Out#

NameDescriptionTypeDefaultUnit
VOLTAGESpecifies at what voltage the device will be forcibly powered off to prevent battery drain. It is never recommended to go below 12.1 volts, as it may damage the battery and shorten its life.str12.20V
DURATIONHow long time should the specified voltage remain before taking effect? It is important that this value is lower than any sleep timer period, otherwise the device can power down normally before this condition is met.int240s

Sleep Timer#

Event Driven#

NameDescriptionTypeDefaultUnit
EVENT REGEXOn which event(s) should this sleep timer be enabled?str^vehicle/engine/stopped-
PERIODHow long time after the event has triggered should the device go to sleep?int1800s
INTERVALHow long time should the device sleep before waking up again?int3600s
DELAYHow long delay before the actual shutdown takes effect?int10s
REASONExplanatory reason for sleeping.strengine_stopped-

Inactivity After Sleep#

NameDescriptionTypeDefaultUnit
PERIODWhen waking up after sleep, how long time will the device stay awake before going to sleep again?int300s
INTERVALHow long time should the device sleep before waking up again?int7200s
DELAYHow long delay before the actual shutdown takes effect?int10s

Inactivity Fallback#

NameDescriptionTypeDefaultUnit
PERIODHow long time should the device stay awake until it is powered down due to inactivity?int300s
INTERVALHow long time should the device sleep before waking up again?int7200s
DELAYHow long delay before the actual shutdown takes effect?int10s

Suppress#

NameDescriptionTypeDefaultUnit
EVENT REGEXWhich event(s) should disable current sleep timers and prevent new ones from being enabled?str^vehicle/engine/running-
SCHEDULESpecifies one or more time periods during which the device must be awake. Added sleep timers are adjusted accordingly to not sleep for the specified time periods. The format consists of a cron expression in UTC, then a pipe sign (|) as separator and finally a duration in seconds. Example: 0 8 * * * | 7200str-

Wake Trigger#

NameDescriptionTypeDefaultUnit
VOLTAGE CHANGEHow much should the voltage change for the device to power up on engine start? Be careful about changing this parameter too much, as it could prevent your dongle from powering on.str+0.50V
VOLTAGE CHANGE DURATIONHow long should the specified voltage change be observed before the device powers up on engine start?int1000ms
VOLTAGE LEVELAt what voltage level should the device power on?->13.20V
VOLTAGE LEVEL DURATIONHow long should the specified voltage level be observed before the device powers on?int3s