Power

Battery

Name	Description	Type	Default	Unit
READ INTERVAL	How often should the battery voltage be read out and checked? Disabled if set to zero.	int	5	s

Critical Level

Name	Description	Type	Default	Unit
DURATION	How long should the specified voltage remain before triggering the 'vehicle/battery/critical_level' event.	int	180	s
VOLTAGE	Specifies the voltage threshold where the device should trigger the 'vehicle/battery/critical_level' event and then go into hibernation. To have any effect, this value must be greater than the safety cut-out voltage.	float	-	V

Firmware

Name	Description	Type	Default	Unit
VERSION	Version number of the power management firmware.	str	3.1	-
AUTO UPDATE	Automatic update of the firmware on the power management chip?	bool	True	-

Modem

Name	Description	Type	Default	Unit
POWER SAVE	Put modem into lower power mode during sleep? When enabled it is no longer possible to wakup device on SMS.	bool	True	-

Safety Cut-Out

Name	Description	Type	Default	Unit
DURATION	How long time should the specified voltage remain before taking effect? It is important that this value is lower than any sleep timer period, otherwise the device can power down normally before this condition is met.	int	240	s
VOLTAGE	Specifies at what voltage the device will be forcibly powered off to prevent battery drain. It is never recommended to go below 12.1 volts, as it may damage the battery and shorten its life.	str	12.20	V

Sleep Timer

Event Driven

Name	Description	Type	Default	Unit
INTERVAL	How long time should the device sleep before waking up again?	int	3600	s
REASON	Explanatory reason for sleeping.	str	engine_stopped	-
DELAY	How long delay before the actual shutdown takes effect?	int	10	s
PERIOD	How long time after the event has triggered should the device go to sleep?	int	1800	s
EVENT REGEX	On which event(s) should this sleep timer be enabled?	str	^vehicle/engine/stopped	-

Inactivity After Sleep

Name	Description	Type	Default	Unit
INTERVAL	How long time should the device sleep before waking up again?	int	21600	s
PERIOD	When waking up after sleep, how long time will the device stay awake before going to sleep again?	int	300	s
DELAY	How long delay before the actual shutdown takes effect?	int	10	s

Inactivity Fallback

Name	Description	Type	Default	Unit
INTERVAL	How long time should the device sleep before waking up again?	int	21600	s
DELAY	How long delay before the actual shutdown takes effect?	int	10	s
PERIOD	How long time should the device stay awake until it is powered down due to inactivity?	int	300	s

Suppress

Name	Description	Type	Default	Unit
SCHEDULE	Specifies one or more time periods during which the device must be awake. Added sleep timers are adjusted accordingly to not sleep for the specified time periods. The format consists of a cron expression in UTC, then a pipe sign (|) as separator and finally a duration in seconds. Example: 0 8 * * *	7200	str
EVENT REGEX	Which event(s) should disable current sleep timers and prevent new ones from being enabled?	str	^vehicle/engine/running	-

Wake Trigger

Name	Description	Type	Default	Unit
VOLTAGE CHANGE	How much should the voltage change for the device to power up on engine start? Be careful about changing this parameter too much, as it could prevent your dongle from powering on.	str	+0.50	V
VOLTAGE LEVEL	At what voltage level should the device power on?	-	-	V
VOLTAGE CHANGE DURATION	How long should the specified voltage change be observed before the device powers up on engine start?	int	1000	ms
VOLTAGE LEVEL DURATION	How long should the specified voltage level be observed before the device powers on?	int	3	s